For all of your push pull silt fence needs, contact the experts at Silt Fence Plow today.
*Please Note: Due to McCormick Equipment’s continual improvements of its products, production changes may cause your machine to appear slightly different in detail.View Brochure
Provides easy on and off. Both have retractable legs to keep the machines steady when unhooked.
This simple design allows you to adjust the amount of tension on the chute when it is out of the ground. It is on the machine to prevent slapping of the chute when transporting the machine. Simply tighten or loosen the bolts to allow more or less tension.
Easy moving. 6”x 4” x 3/8” Tube Steel Main Frame for the strongest built plow in the industry.
Allows you to quickly offset to either side of center to pull. It allows you to swing the machine over either side of center to push the silt fence plow forward. By aligning two pins the machines offset position can be changed while it is in the ground.
The rear pivot can swing 90° either side of center. The rear pivot design provides the tightest turning radius available. Massive 2” x 8” pivot pins ensure years of dependable service.
Simple easy to adjust fabric tension spring allows for quick adjustment. 16” Diameter fabric plates prevent the fabric from telescoping over the plates during installation.
Comes with hardened steel blade cuts through tree roots and vegetation.
This is standard equipment. Stainless steel parts in key wear areas and specially designed fabric chute installs fabric in a tight consistent snag free manner.
Designed to disrupt the soil upward for easier pulling and proper silt fence installation.
The cutting tooth can be bought at any dealer who sells replacement cutting teeth for excavators or skid loaders. It is not proprietary to "The Silt Fence Plow" The coulter cuts through tree roots,grass and other material that can hang up around the moleboard knife.
This picture shows the difference of the 36" and 48" chutes. A 36" chute is the most common height of silt fence installed. The 36" chute will install 36" tall and shorter fabric. The 48" chute will install 48" tall and shorter fabric.
The wire unroller mounts on either side of the machine. It allows a roll of wire to be unrolled as the fabric is being sliced into the ground. It will not install the wire into the ground. If you need to install the wire and the fabric into the ground together look at the Enfencer machine on our website. With the Push Pull model the wire unroller can only be used in the backwards position.
The fabric curtain is a plastic divider that separates the fabric so it does not rub against itself when going through the fabric chute. It is only needed when using non woven fabrics to prevent the fabric from grabbing itself and pulling down. With the slick woven fabric, the divider is not needed.